Bosch HFM 5 Views. 3 years ago. No tags were found READ. Bosch HFM 5 READ. Show more . Robert Bosch GmbH. Automotive Aftermarket. Postfach Karlsruhe . Germany Hot-film air mass meter, type HFM 5. Bosch: – 5 way Female Compact Connector m for Bosch HFM5 Airflowsensor.

Author: Kajirr Moogulkis
Country: Barbados
Language: English (Spanish)
Genre: Health and Food
Published (Last): 27 October 2014
Pages: 485
PDF File Size: 10.55 Mb
ePub File Size: 3.39 Mb
ISBN: 496-8-73684-150-6
Downloads: 88416
Price: Free* [*Free Regsitration Required]
Uploader: Kacage

The one I’m using was used in many VWs around – or so.

Return to MS3 General Support. See also MS3 manuals.

Is anyone else using one of these sensors? The way the MS firmware works if it sees an input value below the lowest entry in the table, it’ll just use the number corresponding to the lowest entry. This is a pretty old late 80’s – early 90’s MAF sensor that returns a V signal and hdm5 no reverse flow detection.

Google [Bot] and 3 guests.

I’m considering upgrading to the Bosch HFM5 sensor that does have reverse flow detection. I can supply, repair or upgrade Megasquirts in UK. Users browsing this forum: The integrator value would then be used to calculate the amount boscg fuel to inject.


As far as I know the MS3 firmware doesn’t support negative flow values, I’m not even sure what one would do with that info?

Air flow sensor | Autoscope | Autoscope Technology

You would integrate the flow, then just before the time an injector is going to fire, read the integrator then reset it. I do not believe that V1. I’m curious what other’s have done with the reverse flow output of this sensor, if anything. Board index All times are UTC. Bodch also outputs a V signal but the difference is that no flow produces 1V output.

I will see in a week or so when I install it on my engine. I think the HFM5 sensor and similar sensors can sense the reverse flow and take it into account and still produce a positive flow reading as long as the positive flow is greater than the negative flow. The HFM2 is open to both forward and reverse flow equally whereas the HFM5 is open only to forward flow and the data sheet claims that it accounts for reverse flow.

  AR 350-51 PDF

I was curious if anyone had found a practical use for the “negative” flow reading below 1 volt.

Bosch 1 928 403 836 – 5 way Female Compact Connector 1.1m for Bosch HFM5 Airflowsensor

Thanks for the replies. Or boosch this case, in less gibberish terms, the Megasquirt will see 0 flow for all voltages of 1. I do not expect to need the negative flow output range volt. America needs more lerts.

Air Mass Sensor Bosch Flow Meter Hfm5 Quality Replacement | eBay

I’m hoping the HFM5 will do a better job. I noticed that hfj5 Bosch data sheets show the negative flow reading and some just show the sensor output starting at 1 volt and don’t publish the volt data at all. It would be a fundamentally different way of calculating fueling.

Thanks for the information!

Author: admin